Roland TD-4 - Page 42

40
Expanding your drum set
5. Use the SEL [ ] [ ] buttons to choose “8 PAD
SETTINGS,” and press the [OK] button.
The Pad Type screen will appear.
fig.d-Sys-Pad-1.eps
6. Lightly strike the hi-hat; the screen will indicate
“HH.”
7. Use the [-/+] dial to select the VH-11.
8. Press the SEL [ ] button to select “HH Pedal
Sens.”
fig.d-VH11-Offset.eps
9. While you watch the meter that’s shown in the
lower part of the screen, turn the VH-11’s VH offset
adjustment screw to adjust it.
Adjust the screw so that the meter indicates “ ”.
fig.Offset-Adj.eps
fig.VH-Offset.eps
10. Adjust other parameters as needed.
If you don’t set up the VH-11 correctly, it may not operate
correctly. For details, refer to the VH-11 owner’s manual.
Correct
VH Oset
Adjustment
Screw
OPEN CLOSE
VH Offset Adjustment Points
If the closed hi-hat sound is difficult to attain, rotate the
VH offset adjustment screw towards “CLOSE.”
If the open hi-hat sound is difficult to attain, rotate the
screw towards “OPEN.”
If the sound cuts off when you strike the hi-hat forcefully,
rotate the VH Offset adjustment screw towards “OPEN.”
TD-4_e.book 40 ページ ２００８年１１月５日 水曜日 午後６時４０分