Roland TD-4KP - Adjusting the Volume of the Pads or Drum Kit (MIXER)

28
Creating a Drum Kit
Adjusting the volume and pan (stereo position) of individual pads/pedals.
1. In the menu screen, choose “2 MIXER” and press
the [OK] button.
The “Mixer” screen will appear.
fig.
2. Use the SEL[ ] [ ]buttons to select a
parameter.
3. If the parameter is “Pad Volume” or “Pan,” strike a
pad to select the pad whose setting you want to
edit.
The pad you struck will blink in the screen.
4. Use the [-/+] dial to edit the setting.
5. Press the [OK] button to return to the “MENU”
screen.
• If Head/Rim Link (p. 36) is ON, the Pad Volume and Pan settings of the Head and Rim (or for a cymbal, the bow and edge) will be
edited simultaneously for SNARE, HH, CRASH, and RIDE. The screen will indicate the value of the setting for the head (or for a cymbal,
the bow). If Head/Rim Link is OFF, strike the pad’s head or rim (or for a cymbal, the bow or edge) to select the setting you want to edit.
• If Head/Rim Link (p. 36) is ON, and the Pad Volume and Pan of the head and rim (or for a cymbal, the bow and edge) have different
values, an “*” will appear at the right side of the screen.
Adjusting the volume of the pads or drum kit (MIXER)
Screen Parameter Value Explanation
Pad Volume 0–100
Volume of each pad
* Use the HH Pedal Sens setting (p. 35) to
adjust the sensitivity of the hi-hat pedal.
Pan L10–CENTER–10R Pan position of each pad
Kit Volume 0–10 Volume of the entire drum kit
Xstick Volume OFF, 1–3
Cross stick volume
Raising this value will increase the volume of the
cross stick.
For a value of 1–3, the Drum Kit screen will indi-
cate “Xstick.”
When set to “OFF,” playing cross stick will pro-
duce the open rim shot sound.
* Use the Xstick Adjust setting (p. 35) to adjust
the level of the striking force at which the
switch between the cross stick sound and the
open rim shot sound will be made.
TD-4_e.book 28 ページ ２０１２年９月１０日 月曜日 午後１時４３分