Roland V-Combo VR-760 - Adjusting the Sensitivity of the D Beam Controller

50
Using the Advanced Functions
■ Adjusting the Sensitivity of the D Beam Controller
Caution
When the VR-760 automatically calibrates the sensitivity of the D Beam
controller, make sure no object is placed on the D Beam, and avoid having
your hands near it.
Also, please be aware that the D Beam will not function in a location where
there is a large amount of infrared light.
1. Simultaneously press the D BEAM CONTROLLER
[ROTARY SPEED] button and the [ENTER] button.
The following screen is displayed for approximately two seconds, and the D
Beam controller sensitivity is automatically adjusted.
* Never turn off the power while the following screen is being displayed.
fig.05-03ÅiD BEAM Calibrated!!Åj
Although the D Beam sensitivity setting is saved within the VR-760 even
after the power is turned off, the setting cannot be saved to cards.
You can set the D Beam
sensitivity manually. Refer
to “Adjusting the
Sensitivity of the D Beam
(p. 67).”