4
Getting Ready
Turning On the Power
1
Before turning on the V-Synth’s power, consider these two questions:
• Are all peripheral devices connected correctly?
• Have the volume controls of the V-Synth and all connected audio devices been
turned to their lowest settings?
2
Turn on the POWER switch located on the rear panel of the V-Synth.
fig.Q-02.e
3
Turn on the power for any connected amplifiers or speakers.
4
Wait for the V-Synth to start up. When it has started up normally, a
screen like the following will appear.
fig.Q-02a_60
5
Set the volume for your connected amplifier and speakers. While
playing the V-Synth keyboard, gradually raise the V-Synth’s volume
slider to the desired listening level.
fig.Q-03
Once the connections have
een completed (p. 3), turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunctions and/or damage
to speakers and other devices.
ON OFF
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
To ensure proper operation of
the pitch bend lever, make
sure not to touch the lever
when turning the V-Synth’s
power on.
While the V-Synth is starting
up, the display will indicate
“Processing...”
Be careful not to set your
listening volume too high to
avoid damage to your amp/
speaker system or your
hearing.
In order to obtain the best
audio quality from the V-
Synth, we recommend that
you set the V-Synth’s volume
to the maximum position, and
adjust the volume
appropriately on your amp or
speaker system.
To Next Page
Loading...
Need help?
General
