VS-2480 Tip Sheet ©2001 Roland Corporation US 13
Setting Region Edit Points by Dragging
1. Press PHRASE•REGION•AUTOMIX repeatedly until it’s lit red.
2. Click and hold the left mouse button at the desired IN point, making sure you click
after the start of the project.
3. Drag rightward across the display and release the button at the desired OUT point.
4. To re-do the operation, repeat Steps 2 and 3.
Selecting One or More Phrases and Regions
While you can select audio as described earlier—or by using the ENTER/YES button
(Page 22)—you can also use the mouse and the SELECT PHRASE and SELECT TRACK
Pop-Up Menus. This can be handy when you want to select multiple phrases or regions.
To select one or more phrases using the SELECT PHRASE pop-up:
1. Press PHRASE•REGION•AUTOMIX repeatedly until it’s lit green.
2. Turn the TIME/VALUE dial to place the timeline over the desired
phrase(s).
3. Right-click any track number to the left of the playlist.
4. In the SELECT PHRASE Pop-Up Menu, you can see which tracks
contain a phrase at the timeline’s current position. Click each desired
track to select its phrase. Click a track again to unselect its phrase.
5. Click EXIT when you’re done—all phrases that touch the timeline on the selected
tracks are now ready to be edited.
To select one or more regions using the SELECT TRACK pop-up:
1. Press PHRASE•REGION•AUTOMIX repeatedly until it’s lit red.
2. Make sure your IN and OUT points are set as desired.
3. Right click on any track number to the left of the playlist—the
SELECT TRACK Pop-Up Menu appears.
4. Click each track that contains a region you want to select, or click the
track again to unselect its region.
5. Click EXIT when you’re done—all audio that falls between the IN and OUT points
on the selected tracks is now ready to be edited.
You can also drag from right to left, setting the OUT and then the IN and FROM points.
As you drag, any audio that you drag across is also selected. To un-select any of this
audio, cursor to its track and press ENTER/YES. Press ENTER/YES again to re-select it.
Click ALL to checkmark all of the tracks, or click it again to un-check all of the tracks.
Click ALL to checkmark all of the tracks, or click it again to un-check all of the tracks.
To Next Page
Loading...
