8 ©2001 Roland Corporation US VS-2480 Tip Sheet
About VGA, Mouse and Keyboard Configuration Parameters
Once you’ve powered up, you’ll want to make sure your mouse, keyboard and VGA
monitor are properly configured. All of the parameters for these devices—described in
the following sections—are found on the same UTILITY Menu page. To get there:
1. Press UTILITY.
2. Press PAGE—if necessary—until SYSTEM appears above F1.
3. Press F1 (SYSTEM).
4. Press F2 (Param2).
5. Press
"
,
#
,
$
and/or
%
to select each desired parameter and turn the
TIME/VALUE dial to set its value.
Using a VGA Monitor with the VS-2480
Configuring Your Monitor
VGA Parameters
Elements of the Info Display
Most of the VS-2480 Info Display’s screens are divided into four areas.
Parameter: What it sets: Typical setting is:
VGA OUT Turns the VGA output on or off On
REFRESH RATE Sets the amount of monitor flicker Manufacturer’s
recommended setting,
or highest value that
looks good on monitor
H. POSITION Shifts the image left or right 0
V. POSITION Shifts the image up or down 0
The Info Display also provides a date and time readout in its upper right-hand corner.
General Information Strip
PAN/AUX SEND 1-8 Strip
Meters Strip
Bottom Pane
To Next Page
Loading...
