22 ©2001 Roland Corporation US VS-2480 Tip Sheet
Setting IN, OUT FROM and TO
You can set edit points by positioning the timeline at the desired location and pressing
the IN, OUT, FROM or TO button, respectively, or by using the mouse (Page 13).
Edit Point Flags
On the VS-2480 display, each edit point is shown as a line
with a flag at its top. Each point its own distinct flag.
Selecting Audio for Editing
There are two basic steps to selecting audio you want to edit:
1. Cursor to the track on which the desired audio resides.
2. Select the phrase or region as described below.
Cursoring to a Track
You can cursor to a track on the Home screen in a couple of ways:
• You can press $ or % to move the cursor to the desired track.
• You can click on the track with your mouse (Page 12).
When a track is selected, a triangle appears to its left and the track turns white.
On the Wave Display, you can select a new track using the $ or % buttons.
Selecting a Phrase
1. Move the cursor to the track containing the desired phrase.
2. Turn the TIME/VALUE dial so the timeline touches the phrase.
3. Press ENTER/YES to select the phrase. To unselect it, press ENTER/YES again.
Selecting a Region
1. Move the cursor to the track containing the desired region.
2. Press ENTER/YES to select the audio on the track that falls between the IN and
OUT points. To unselect the region, press ENTER/YES again.
To move the timeline to the IN, OUT, FROM or TO locations, hold down SHIFT and
press the desired IN, OUT, FROM or TO button.
Since the FROM point is set to the same location as
the IN point by default, you won’t always see its
flag—it may be covered by the IN point.
If you select audio on one of a pair of linked tracks, the audio on
the other linked track is also selected.
IN FROM OUT TO
Selected phrases
Selected regions
When audio is
selected, it has a
dotted outline. If
you cursor to its
track, it’s white. If
not, it’s black.
Track turns white
Triangle
To Next Page
Loading...
