130
<Procedure>
❶ Make sure that the Track Edit Menu display
(SEQ/TrkEdit) is up.
❷ Press [F6] (Menu) to select Menu 2, then press [F3]
(Chg Gt) to call up the Change Gate Time display
(SEQ/TrkEdit).
This display can also be called up by moving the cursor to “8
Chg Gate Time” and pressing [ENTER] on the Track Edit
Menu display (SEQ/TrkEdit). Or press the numeric key [8],
then [ENTER].
❸ Move the cursor to Target track and select the Phrase
track(s) or Pattern whose gate time you want to modi-
fy.
❹ When setting the editing area by measures, move the
cursor to “Measure” and specify the measure number
at which gate time change will begin, then move the
cursor to “for” to specify the measure length over
which gate time will be modified.
When using Locate positions, press [LOCATE], and move
the cursor to “From” to select the Locate number from where
you want gate time change to begin. Then move the cursor
to “to” and select the Locate number where you want gate
time change to end. 5. Move the cursor to “Bias” and set the
amount of gate time addition.
❻ Move the cursor to “Magnify” and set the ratio of gate
time variation.
❼ Move the cursor to “Channel” and select the MIDI
channel(s) of notes for which gate time will be modi-
fied.
❽ Move the cursor to “Note Range” and set the note
number range in which gate time will be modified.
You can also set this parameter through key input on the
keyboard.
❾ Press [F6] (Execute) to begin gate time change.
Combining two Phrase Tracks/Patterns
into one – 9 Merge
This function merges (combines) sequencer data of two
Phrase tracks or Patterns into one (of them).
Source track
Selects one of the Phrase tracks or Patterns to be merged.
After merging is completed, original sequencer data in this
track or Pattern will be erased.
TRK 1–TRK 16: The specified Phrase track
PTN 001–PTN 100: The specified Pattern
Destination track
Selects the other Phrase track or Pattern for merging. After
merging, the combined sequencer data will be inserted into
this track or Pattern.
TRK 1–TRK 16: The specified Phrase track
PTN 001–PTN 100: The specified Pattern
<Procedure>
❶ Make sure that the Track Edit Menu display
(SEQ/TrkEdit) is up.
❷ Press [F6] (Menu) to select Menu 2, then press [F4]
(Merge) to call up the Merge display (SEQ/TrkEdit).
This display can also be called up by moving the cursor to “9
Merge” and pressing [ENTER] on the Track Edit Menu dis-
play (SEQ/TrkEdit). Or press the numeric key [9], then
[ENTER].
❸ Move the cursor to Source track and select a Phrase
track or Pattern you want to merge.
❹ Move the cursor to the Destination track and select the
other Phrase track or Pattern to be combined (merge
destination).
❺ Press [F6] (Execute) to merge data.
✳ Source and Destination parameters cannot be set to the
same setting. If you execute the operation with the
same setting, the display will show “Same Track or
Pattern Selected.” Select different Phrase tracks or
Patterns and execute the operation again.
To Next Page
Loading...
