92
Assigning sliders, pedals and other con-
trollers (Control)
✳ The Control group consists of three display pages –
Control Assign, Pedal Assign and Control Source. To
change the display page, press [F4] (Control).
Control Assign display
This display is for assigning the function of each slider.
C1 Slider
C2 Slider
Specifies the function of the C1 slider and C2 slider, respec-
tively.
Use the Assign parameter to specify the functions controlled
by each slider.
CC01–95: Controller numbers 1–95 (except for 6, 32–63).
PITCH BEND: Pitch bend
AFTERTOUCH: Aftertouch
Use the Output parameter to select the sound source(s) (the
internal sound source and/or external sound sources con-
nected to MIDI OUT connector) to be controlled by the slid-
ers.
OFF: Neither will be controlled.
INT: Only the internal sound source will be controlled.
MIDI: Only external sound sources will be controlled.
INT&MIDI: Both the internal sound source and external
sound sources will be controlled.
Sys-Ctrl1 (System Controller 1)
Sys-Ctrl2 (System Controller 2)
These parameters allow you to choose up to two controllers
for common use for controlling Patch or Performance para-
meters. The settings in each Patch (or Performance) deter-
mines which of the two controllers you choose here will
actually be used. You also need to specify the parameters to
be controlled for each Patch (or Performance).
Use the Assign parameter to specify functions controlled by
each slider.
CC01–95: Controller numbers 1–95 (except for 6, 32–63).
PITCH BEND: Pitch bend
AFTERTOUCH: Aftertouch
✳ To use the selected controllers, you need to make nec-
essary System settings and Patch/Performance settings
so that the MIDI messages transmitted by the selected
controllers will be received.
✳ For most control change messages, the function per-
formed by message number is defined in MIDI specifi-
cations. Please note these settings allow you to use
control change messages without regard to officially
defined functions.
Pedal Assign display
Use this display for assigning functions to the pedals.
Pedal 1–Pedal 4
Hold Pedal
Specifies the functions of Pedals 1–4 and the Hold Pedal.
Use the Assign parameter to specify the functions controlled
by each pedal.
✳ Hold Pedal's Assign is fixed at CC64: HOLD-1.
CC01–95: Controller numbers 1–95 (except for 6, 32–63).
PITCH BEND: Pitch bend
AFTERTOUCH: Aftertouch
PROG-UP: Every press of the pedal selects the next
Performance number, Patch number, or Rhythm Set.
PROG-DOWN: Every press of the pedal selects the previous
Performance number, Patch number, or Rhythm Set.
START/STOP: Every press of the pedal makes the sequencer
alternate between playback and stop.
PUNCH-I/O: Every press of the pedal makes the sequencer
alternate between starting and stopping manual punch-in
recording.
TAP-TEMPO: Tap tempo (a tempo specified by the interval
at which you press the pedal).
OCT-UP: Each pedal press raises the key range in octave
steps (up to 3 octaves higher).
OCT-DOWN: Each pedal press lowers the key range in
octave steps (up to 3 octaves lower).
Use the Output parameter to select the sound source(s) (the
internal sound source and/or external sound sources con-
nected to MIDI OUT connector) to be controlled by the
pedal.
OFF: Neither will be controlled.
INT: Only the internal sound source will be controlled.
MIDI: Only external sound sources will be controlled.
INT&MIDI: Both the internal sound source and external
sound sources will be controlled.
Chapter 3. Creating your own sounds
[SYSTEM]➞[F4] (Control)
To Next Page
Loading...
