Roland XP-80 - Page 91

Rx Sys. Excl (Receive system exclusive switch)
For receiving System Exclusive messages, set this ON. If not,
set it OFF.
Tx Edit Data (Transmit edit data switch)
If you want System Exclusive messages to be transmitted for
each change you make while editing a Patch, Performance or
Rhythm Set, set this ON. If not, set it OFF.
Rx GM-ON Message (Receive GM-ON switch)
If you want to receive GM-ON messages, set this ON. If not,
set it OFF.
MIDI Param1 (GM MIDI Parameter) display
When [SYSTEM] is pressed in GM mode, the following dis-
play will appear.
Local Switch
Specifies whether all Parts will be played by the keyboard
(ON) or not (OFF). Normally left ON, but if you use the XP-
80’s keyboard and controllers for controlling only external
sound sources, set this OFF.
✳ It is also possible to set the Local Switch parameters in
the System Parameter window you open by pressing
[LOCAL/TX/RX] then [F2] (System).
Remote Keyboard Switch
Set this parameter ON when you want to use an external
MIDI keyboard instead of the XP-80’s keyboard. In this case,
the transmit channel of the external MIDI keyboard can be
set to any channel. Normally this parameter should be OFF.
✳ Set this parameter ON for performance using the RPS
function to be controlled by an external MIDI device.
Device ID Number
For transmitting or receiving System Exclusive messages, set
this parameter to match the device ID number of the other
MIDI device.
Rx GM-ON Message (Receive GM-ON switch)
If you want to receive GM-ON messages, set this ON. If not,
set it OFF.
MIDI Param 2 (MIDI parameter 2) display
Rx Program Change (Receive program change switch)
If you want to receive Program Change messages, set this
ON. If not, set it OFF.
Rx Bank Select (Receive bank select switch)
If you want to receive Bank Select messages, set this ON. If
not, set it OFF.
Tx Program Change (Transmit program change switch)
If you want to send Program Change messages, set this ON.
If not, set it OFF.
Tx Bank Select (Transmit bank select switch)
If you want to send Bank Select messages, set this ON. If not,
set it OFF.
Tx Active Sensing (Transmit active sensing switch)
If you want to transmit Active Sensing messages, set this
ON. If not, set it OFF.
Bank Select Group display
If you have selected GROUP1–GROUP7 for the Tx Bank
Select parameter (PERFORM/MIDI/MIDI Param), the Bank
Select Group parameter specifies the Bank Select number to
be transmitted for Grp1–Grp7 parameters.
Grp1-Grp7 (Bank select group number 1–7)
Set Bank MSB and Bank LSB for each of <Grp1>–<Grp7>
(group number). Use the Switch parameter to specify
whether Bank Select messages of each group will be trans-
mitted (ON) or not (OFF).
91
Chapter 3. Creating your own sounds
[SYSTEM]➞[F3] (MIDI)