Roland XP-80 - Recalling Factory Default Settings - 8 Factory (Factory Preset)

...........................................................................................................
<Data Reduce>
The Data Reduce function erases data nonessential for play-
back to save memory. This function is useful when an error
message such as “Internal Memory Full” is displayed.
✳ After a Data Reduce function execution, you cannot
undo the procedure.
<Procedure>
❶ Make sure that the Internal Memory Information dis-
play (UTILITY/Memory) is up.
❷ Press [F6] (Reduce).
A window shows a prompt to confirm you really want to
execute.
❸ Press [F5] (OK) to reduce data. To cancel data reduc-
ing, press [F6] (Cancel).
...........................................................................................................
❚
Recalling factory default settings
– 8 Factory (Factory preset)
This function resets all the settings stored in the XP-80 mem-
ory to the factory default settings. Internal memory and
chain settings will also be discarded.
<Procedure>
❶ Make sure that the Utility Menu display (UTILITY) is
up.
❷ Press [F6] (Menu) to select Menu 3, then press [F1]
(Preset) to select Factory Preset.
You can also select Factory Preset by moving the cursor to “8
Factory” and pressing [ENTER] on the Utility Menu display
(UTILITY), or pressing the numeric key [8], then [ENTER].
❸ Press [F6] (Execute) to perform Factory Preset opera-
tion.
After performing Factory Preset operation, the Play display
(PATCH) appears.
✳ If you execute Factory Preset operation with the Write
Operation parameter ON, a window shows “Write
Protect ON.” Reset the parameter OFF to perform
Factory Preset operation. After setting is completed,
press [EXIT] or [ENTER] to close the window. Then
press [F6] (Execute) to perform the operation again.
Once you set it OFF, the Write Operation parameter
will remain OFF until you turn the power off.
165
Chapter 8. XP-80 memory settings (Utility mode)
[UTILITY]➞[8]➞[ENTER]