Pitch Envelope display
This is where to set the pitch envelope (how pitch changes
over time) according to keyboard playing dynamics. The
pitch envelope is displayed graphically.
Time1-4 (Pitch envelope time 1–4)
Sets pitch envelope’s time (Time 1–4). Higher settings extend
the duration over which pitch changes from one point to
another (for example, time for the pitch to change from
Level 1 to Level 2 for Time 2).
Level1-4 (Pitch envelope level 1–4)
Sets pitch envelope level (Level 1–4) to determine pitch of
each point relative to the reference pitch (pitch set for Coarse
Tune or Fine Tune). Positive (+) values will raise pitch over
the reference pitch, and negative (-) values lower pitch
below the reference pitch.
Envelope Depth (Pitch envelope depth)
Adjusts pitch envelope amount. Higher settings produce
more change. Negative (-) values invert the envelope.
Velocity Sens (Pitch envelope velocity sensitivity)
This parameter should be used when you want keyboard
playing dynamics (velocity) to impact on pitch envelope
amount. With positive (+) values, the amount of pitch enve-
lope increases as the key is pressed with increasing force.
Negative (-) values reduce pitch envelope amount as the key
is pressed with increasing force.
Velocity Time 1 (Pitch envelope velocity time 1 sensitivity)
Use this parameter when you want keyboard playing
dynamics (velocity) to impact on the Time1 parameter of the
pitch envelope. With positive (+) settings, a higher keyboard
velocity will reduce (speed up) Time1 value. With negative
(-) settings, higher keyboard velocity will increase (slow
down) Time1 value.
Velocity Time 4 (Pitch envelope velocity time 4 sensitivity)
Use this parameter when you want key release speed to
impact on Time4 value of the pitch envelope. If you want a
quicker release to reduce (speed up) Time4 value, use posi-
tive (+) values. For a quicker release to increase Time4 (slow
down) value, use negative (-) settings.
Time Keyfollow (Pitch envelope time keyfollow)
Use this parameter when you want a pressed key to control
pitch envelope time (Time2–Time4 parameter settings).
Higher settings will have a greater time change relative to
the envelope time at middle C (C4). Positive (+) settings will
reduce the time when keys higher than middle C are
pressed. Negative (-) settings will increase the time for notes
higher than middle C.
To Next Page
Loading...
