MIX: The sound will be output from the MIX OUTPUT jacks
just as it is.
REV: Reverb will be applied.
M+R: The sound will be output from the MIX OUTPUT jacks
and to reverb.
✳ This setting also affects Output parameter (PATCH/
Effects/Chorus) value.
Reverb Level
Adjusts the volume level of the reverb sound.
✳ This setting also affects Level parameter (PATCH/
Effects/Reverb) value.
Output Assign parameter set to EFX
Output Assign
EFX: The direct sound is sent to EFX. After passing through
EFX, the sound proceeds to the destination specified by the
EFX OUTPUT Assign parameter.
Reverb Send Level
Adjusts reverb intensity for each Tone.
Chorus Send Level
Adjusts the amount of chorus for each Tone.
Mix/EFX Send Level
Adjusts the volume level of EFX’d sound for each Tone.
EFX Reverb Send Level
Adjusts reverb intensity applied to the sound that passes
through EFX.
EFX Type
Select EFX type from the 40 types available. Set each EFX
type’s parameters on the EFX display (PATCH/Effects). For
details, refer to “EFX effect types (EFX Parameter)” (p.74).
EFX Chorus Send Level
Adjusts the amount of chorus applied to the sound that
passes through EFX.
EFX Output Level
Adjusts volume level of the output sound that passes
through EFX.
EFX Output Assign
Specifies how the sound passing through EFX will be out-
put.
MIX: The sound that passes through EFX will be output to
the MIX OUTPUT jack. If Chorus and/or Reverb is selected,
all these effects are output together with the direct sound.
DIR: The sound that passes through EFX will be output to
the DIRECT OUTPUT jack. If Chorus and/or Reverb is
selected, these settings have no effect.
Chorus Level
Adjusts volume level of chorus sound.
✳ This setting also affects the Level parameter (PATCH/
Effects/Chorus) value.
Chorus Output Assign
Specifies how chorus sound is to be output.
MIX: The sound will be output from the MIX OUTPUT jacks
just as it is.
REV: Reverb will be applied.
M+R: The sound will be output from the MIX OUTPUT jacks
and to reverb.
✳ This setting also affects the Output parameter
(PATCH/Effects/Chorus) value.
Reverb Level
Adjusts the level of the reverb sound.
✳ This setting also affects the Level parameter (PATCH/
Effects/Reverb) value.
Output Assign parameter set to DIR
Output Assign
DIR: Only the direct sound will be sent to the DIRECT OUT
jack. If Chorus and/or Reverb is selected, the effect settings
have no effect.
Mix/EFX Send Level
Adjusts the volume level of each Tone.
...........................................................................................................
<Effects routing setting examples>
You can set parameters from 1–127. Some parameters do not
have numerical value settings.
To Next Page
Loading...
