14
RolliBot RolliCool 208 Portable AC with Heater User Manual
To Set a Shut off Time
1. When the unit and remote are on, press the timer button on the control panel or the remote.
2. Use the up and down buttons to select the time the AC unit will turn o i.e. selecting “03” will
prompt the unit to turn o in 3 hours’ time etc.
3. After the selection is complete, the display will show the current indoor temperature and the
display’s TIMER light will turn on.
5.2 – Fan Mode
With this mode, the unit will turn on and begin using the fan to promote air circulation.
1. Press the power button on the control panel or the remote.
2. Press the mode button on the control panel or remote multiple times until display’s FAN light
turns on.
3. Use the fan button to switch between fan speeds.
5.3 – Sleep Mode
With this mode, the unit will turn on and begin operating at low speed. This mode is similar to
fan mode at low fan speed and functions as a way to aid sleep especially if you are used to fan
noise around bedtime.
1. Press the power button on the control panel or remote.
2. Press the sleep button on the control panel or remote to turn this mode on.
In sleep mode, the fan speed is automatically set to low and cannot be adjusted.
5.4 – Heat Mode
With this mode, the unit will turn on and begin outputting hot air.
1. Press the power button on the control panel or the remote.
2. Press the mode button on the control panel or remote multiple times until the display’s HEAT
light turns on.
3. Use the up and down buttons to set the desired temperature 61~88°F (16~31°C).
4. Use the fan button to switch between speeds.
5.5 – Dehumidify Mode
With this mode, the unit will turn on and begin removing moisture from the air.
1. Press the power button on the control panel or the remote.
2. Press the mode button on the control panel or remote multiple times until the display’s
DEHUM light turns on.
In dehumidify mode, the fan speed is automatically set to low and cannot be adjusted.
To Next Page
Loading...
