15
RolliBot RolliCool 208 Portable AC with Heater User Manual
5.6 – Cool Mode
With this mode, the unit will turn on and regulate temperature as selected.
1. Press the power button on the control panel or remote.
2. Press the mode button on the control panel or remote multiple times until the display’s COOL
light turns on.
3. Use the up and down buttons to set the desired temperature 61~88°F (16~31°C).
4. Use the fan button to switch between fan speeds.
When cool mode is active, the unit will not turn on if the chosen temperature is higher than the indoor temperature.
Section 6. Maintenance
Proper maintenance will help improve your RolliCool’s performance. Periodically, the RolliCool
will need its lters cleaned. For optimal performance, the lters should be cleaned at least twice
a month.
• If any type of non-routine maintenance is needed, such as any maintenance not described in Section 6 of this
manual, please contact customer service or a certi ed HVAC professional as the unit contains refrigerant.
• Wipe the exterior clean with non-abrasive cloth. If needed, cloth can be dampened with water.
• Do not use harsh chemicals to clean as these may damage the unit.
6.1 – How to Clean the Filters
• Please make sure your AC unit is completely powered o before performing any type of maintenance.
•
Do not scrape the air lters as they may sustain damage.
• A hand vacuum may be used to clean the lters.
• Replace the lters after cleaning. Do not use the RolliCool without the lters.
• If water has been used to clean any lter, ensure it is completely dried before reinstalling. Do NOT dry any lter in direct
sunlight.
Cleaning the Upper & Lower Filters
1. Reach under the notches and remove
the covers on the upper and lower
lters.
2. Remove the lters and soak them in
lukewarm water or use a vacuum to
clean the lters. Mild detergents may
be used.
3. After the lters have completely dried,
reinstall them.
Cover
Cover
Notch
Notch
Filter
Filter
To Next Page
Loading...
