rollibot ROLLICOOL 208 - Draining the Unit

16
RolliBot RolliCool 208 Portable AC with Heater User Manual
6.2 – How to Drain the Unit
In most cases, the AC unit will not require draining. In the event that draining is necessary, the
unit will sound an alarm and the display’s WATER FULL light will turn on to indicate the water
reservoir inside is full.
• Please make sure your AC unit is completely powered o before performing any type of maintenance.
• If relocating the unit before draining, move it carefully so as not to spill the water inside the reservoir.
• Make sure the drainage pipe has adequate space underneath for draining. If using the lower drainage opening, ensure
there is a suitable area for water runo . If using the upper drainage opening, fetch a container for water runo before
connecting the pipe.
• Keep the drainage cover and the water plug on at all times when not draining the unit.
• When draining the unit, do not allow the power cord to come in contact with water.
• During drainage, the unit may be tilted slight backwards to promote faster drainage.
• Keep in mind the unit may hold more water than expected. If using a container, do not use a small one or either take care of
drainage outdoors.
Using the Upper & Lower Drainage Openings
1. Turn o and unplug the unit, then move it to a
suitable location for drainage. Place a container
near the unit for water runo if needed; place the
end of the drainage pipe in the container.
2. Remove the cap from the opening and connect
the drainage pipe to the unit via the opening.
If the drainage pipe is too sti and/or cannot be attached, try
soaking the end in hot water to soften it  rst.
3. Allow the water to drain.
After draining is complete, it is recommended to turn the unit on and
run it in Fan Mode at the lowest speed for at least two hours in order
to ensure the Drainage Pipe dries inside.
4. Detach the pipe and reinstall the cap.
Section 7. Storage
Before storing your RolliCool 208, select a dry, indoor
environment. Properly storing your RolliCool will help
improve performance and battery life expectancy.
Step 1. Turn the AC unit o .
Step 2. Remove the heat exhaust pipe and window kit as needed for storage with the unit.
Step 3. Drain the unit of any water and ensure all parts are completely dry.
Step 4. Turn the unit on and run it in fan mode at the lowest speed for at least two hours in
order to ensure the inner reservoir is dried inside.
Step 5. Turn o the unit and install the power cord’s plug into its  xture on the back of the unit.
Step 6. Remove the remote batteries and store separately.