you to change the apparent key priority, or layering, of
the keys in the video output. For example, key 3 appears
over key 2. If you perform a swap between key 3 and
key 2, it appears as if key 2 is now over key 3.
Keep the following in mind when performing a key
swap:
• Key swap does not change the on-air status of a keyer.
• If a DVE key is set to freeze, it will be unfrozen by
the swap.
• A key swap can be recorded as part of a custom
control.
• You cannot swap between keyers on different MEs
on a C10/C1 control panel.
To Perform a Key Swap
This procedure swaps the contents of Key 2 and Key 3
as an example. Use the same procedure for any key
combination.
1.
Press and hold the KEY 2 SEL button.
2.
Press the KEY 3 button in the next transition area.
46 • Keying — Carbonite Operation Manual (v13.0)
To Next Page
Loading...
