Ross HD DVB-S2 1201 - USB Module Functions

5.4.3 Factory Default
This enables the User to return the receiver to the
settings that were made in the Factory. It is useful
if some changes that you have made have
stopped your Receiver from working properly.
There are two options in this menu - DEFAULT
ALL and DELETE ALL CHANNELS. Press OK to
access these two choices.
• DefaultAll: This provides the full FACTORY DEFAULT reset. Press OK, you will then be
prompted to enter the PASSWORD (this is the same as the Parental Control password)
and then finally prompted to confirm that you wish to carry out the reset operation.
Press CANCEL if you have changed your mind or OK to confirm.
• DeleteAllChannels:Press the CH- button to select DELETE ALL CHANNELS, Press
OK, you will then be prompted to enter the PASSWORD (this is the same as the
Parental Control password) and then finally prompted to confirm that you wish to carry
out the deletion operation. Press CANCEL if you have changed your mind or OK to
confirm.
NOTE:IfyoucarryoutaDELETEALLCHANNELSyouwillneedtoperforma
DEFAULTALLafterwardsinordertorestoreyourpreloadedprogrammes.
5.5 USB Module
A USB Device can be connected to the USB Port located on the Side of the unit. Com-
patible devices are USB Memory Sticks* and most types of USB HDD* devices.
(*MOST FAT32 and NTFS devices supported up-to 999GB)
You can use the USB device to: play files, play games, record programmes and update
the Receiver software through the USB port. Press MENU and then using the CH-
button scroll down to USB MODULE and press OK. Available functions are MULTIMEDIA,
SOFTWARE UPGRADE, DATABASE BACKUP, DATABASE UPDATE, PVR PARTITION
SELECT and PVR PREVIEW. Use the CH- button to select your desired function and then
press OK.
17