XPression Prime Maintenance Guide (v01) Maintenance • 3–1
Maintenance
This chapter provides information on maintaining the XPression Prime system.
Front Door Filter Maintenance
The front door on the XPression Prime system comes equipped with two mesh filters to protect the inside of the
XPression system from dust and debris.
Ross Video recommends that the following filter maintenance be performed:
• Periodically check the filter for dust and debris buildup and clean the filter.
• Replace the filter if it is damaged or worn.
Cleaning the Front Door Filters
The mesh filter can be cleaned with a soft brush, cloth, or vacuum as needed. If the filter requires a more thorough
cleaning, it can be removed from the door and washed with a mild soap and water solution.
The filter must be completely dry before it is reinstalled in the door.
Removing the Front Door Filters
To remove the filters from the front door of the XPression Prime system:
1. Open the front door of the XPression Prime system.
Caution — Danger of Explosion if the system lithium battery is incorrectly replaced. Replace only with
the same or equivalent type of battery recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions by a qualified service person.
To Next Page
Loading...
