AC-215 Single and Double Door Access Control Unit
Hardware Installation Guide
9
Card Readers
Two card readers can be connected to the ACU. The following should be defined:
Single door controller:
Door 1 – Reader 1 IN/OUT/auxiliary
Reader 2 IN/OUT/auxiliary
Double door controller:
Door 1 – Reader 1 IN/OUT
Door 2 – Reader 2 IN/OUT
The readers can be assigned to a single or double door controller’s door as an IN or OUT
reader and can activate the auxiliary output in a single door configuration.
The reader’s tamper connects to the ACU and can generate an alarm. The reader’s green
LED input is activated by the ACU when in the Card and PIN secure mode to inform the user
to enter his personal PIN number after entering his card.
Keypad
Two keypads can be alternatively connected to the ACU on Reader1 and Reader2 terminals.
The following should be defined:
Single door controller:
Door 1 Keypad - Reader 1 IN/OUT
Keypad - Reader 2 IN/OUT
Double door controller:
Door 1 Keypad - Reader 1 IN/OUT
Door 2 Keypad - Reader 2 IN/OUT
The keypad type must be a Rosslare format keypad.
A keypad has to be connected for any reader mode that requires PIN code entries, such as
Card or PIN, PIN only or Card and PIN (Secured mode).
To Next Page
Loading...
Need help?
General
