Reader Operation
AYC-x6355 Installation and User Manual 17
5. Reader Operation
Once the reader is wired to a power supply and to the controller, you
should test the reader.
1. Power up the reader.
To indicate that the reader is working properly, the reader flashes
red, then green, and then orange, each for 1 second and a beep
is heard for each color. The LED returns to its idle state (red).
2. Present the appropriate type of proximity card to the reader.
The LED momentarily flashes green and a short beep is emitted
indicating that the card was read properly by the reader.
The reader transmits the card's data to the controller.
To Next Page
Loading...
Need help?
General
