Reader Functionality
AYC-x6355 Installation and User Manual 21
7.2.1 Entering Programming Mode
To reach the Programming Menu System, the AYC-x6355 must first
be placed into Programming mode.
To enter Programming mode:
1. Press # 4 times.
The Transmit LED turns off and
the Program LED turns red.
2. Enter your 4-digit Programming
code.
If the Programming code is valid,
the Door LED turns
unit enters Programming mode.
• The factory 4-digit Programming code is 1234.
• If a Programming code is not entered within 20 seconds, the unit
returns to Transmit mode.
7.2.2 Exiting Programming Mode
To exit Programming mode:
1. Press # to exit the Programming
mode at any time.
You hear a beep.
The Program LED turns off and the Transmit LED turns red.
This indicates that the unit has returned to Transmit mode.
Wrong entries may reset the reader back to Transmit mode.
While in Programming mode, if no key is pressed for 20 seconds,
the unit exits Programming mode and returns to Transmit mode.
To Next Page
Loading...
Need help?
General
