Rosslare AYC-Q54B - Changing Auxiliary Code

Controller Functionality
AYC-Qx4 family manual Page 37
When the first user is added to the controller, the default Lock
Strike Code will automatically be deleted. Once the code is
programmed again, it will not be deleted with the entry of
additional User Codes.
1) Enter Programming mode.
2) Press “1” to enter Menu 1.
• The Mode LED will turn
red.
3) Enter the new code you wish to set
as the Lock Strike Code.
4) System returns to Normal
mode.
• You will hear three beeps.
Note:
• Lock Strike Code does not work in the Secure Mode.
• Wrong entries will return the controller to Normal Mode.
• Code 0000 will erase the Lock Strike Code.
• The factory Default 4-digit Lock Strike code is 2580.
Changing Auxiliary Code
The Auxiliary Code is mainly used as a method to quickly test the
Auxiliary Relay during installation.
When the first user is added to the controller, the default Auxiliary
Code will automatically be deleted. Once the code is
programmed again, it will not be deleted with the entry of
additional User Codes.
1) Enter Programming mode.
2) Press “2” to enter Menu 2.
• The Mode LED will turn
orange.
1
??? ?
2
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Pro
g
ram
Red
Green
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Oran
g
e Green