EasyManuals Logo

Rotary 100 Series User Manual

Rotary 100 Series
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
6
5. Safety
5.1 Warning
Read this chapter carefully and completely since
important information for the safety of the operator
or others in case of improper use of the lift is
included.
FAILURE TO COMPLY WITH THESE
REGULATIONS CAN CAUSE SERIOUS INJURY
TO PERSONS, AND IRREPERABLE DAMAGE TO
THE LIFT AND THE VEHICLE BEIN LIFTED.
1 - Daily inspect your lift. Never operate if it
malfunctions or if it has broken or damaged parts.
Use only qualified lift service personnel and genuine
Rotary parts to make repairs.
2 - During lif
ting or lowering operations, the car
lift must be operated only from the operator’s
control site, as shown in the picture 4.
3 - Stopping or passing within the danger area
when the lift is working or already lifted is strictly
forbidden. Working personnel only is allowed to
stay near the lift.
4 - The operator must make sure the danger area
is empty before lifting or lowering the lift.
5 - Never use the machine without protection or
when the safety de
vices are out.
6- Always use the rubber pads when lifting a
vehicle, observing the proper support points
specified by the vehicle’s manufacturer. (see
chapter 7)
7
7 - To prevent the vehicle from falling make sure
it is properly placed on the lift.
8 - Getting on the vehicle and/or starting the
engine during lifting is strictly forbidden.
9 - Never leave objects and/or obstructions under
the vehicle during the lowering phase.
10 - Always keep area
around lift free of tools,
debris, grease and oil to avoid the risk of slipping.
11 - Always keep platforms and ramps clean.
12 - Never use water steam varnish solvent jets
in the car lift area, and particularly next to the
control box.
13 - Proper lighting is extremely important.
Make sure all areas to the car lift are well and
uniformly lightened, according to the laws of the
country where the lift is installed.
14 - Climbing on the
platforms when lifting the
vehicle or when the same has been already lifted is
strictly forbidden.
15 - Any use of the car lift other than what
herein specified can cause serious accidents to the
operator as well as to the people in close proximity.
16 - Never exceed the maximum carrying
capacity of 3000 kg when using the car lifts.
17 - Replace all control warnings, or safety
related decals on the lift when unable to read or
missing.
18 - Normal
operating temperature range is
C (45°F) to 38° (100° F).

Other manuals for Rotary 100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotary 100 Series and is the answer not in the manual?

Rotary 100 Series Specifications

General IconGeneral
BrandRotary
Model100 Series
CategoryLifting Systems
LanguageEnglish

Related product manuals