Rotary 100 Series User Manual

11
8. Maintenance
WARNING If you are not completely familiar
with automotive lift maintenance procedures STOP:
Contact factory for instructions.
To Avoid Personal Injury, permit only qualified
lift service personnel to perform maintenance on
this equipment.
Use only original equipment manufacturer
approved replacement parts for repairs.
• Always keep all bolts and nuts tight. Check
periodically.
• Always raise lift when cleaning floor area.
• Always keep lift clean. Keep bottom weldment
dry and free from corrosives such as salt and
cleaning fluids.
• Daily: Inspect rubber blocks for damage or
excessive wear. Replace as required with genuine
Rotary parts.
• Weekly: Inspect all lift parts for signs of
damage due to overloading
and rough handling.
• Weekly: Empty water and refill oil as needed
for filter regulator lubricants.
• Monthly: Lightly grease sliding surfaces and
top cylinder clevis pin with all-purpose grease.
• Semi-Annually: Check fluid level of lift power
unit while lift is fully lowered. Refill if required per
fill line on tank. If fluid is required, inspect all hoses
and seals. Repair or replace as required.
• Semi-Annually: Check anchor bolts to ensure
they are torqued to 25ft.lbs.
• If lift stops short of full rise or chatters, check
fluid level and purge both cylinders per lift
installation instructions.
• Replace all CAUTION, WARNING, or SAFETY
related decals on the lift if unable to read or missing.
Reorder labels fr
om Rotary Lift.
• Semi-Annually: If you have ordered the anchor
bolts. Check anchor bolts to ensure they are
torqued to 60Nm.
• If lift stops short of full rise or chatters, check
fluid level and purge both cylinders per lift
installation instructions.
• Replace all CAUTION, WARNING, or SAFETY
related decals on the lift if unable to read or missing.
Reorder labels from Rotary Lift.

Rotary 100 Series Specifications

General

Brand	Rotary
Model	100 Series
Category	Lifting Systems
Language	English