Rotenso CONTROL Series - Controller Address Selection; Restore Factory Settings

LOKA HAHB remote control
EN
95
Installation and user manual
When the air conditioning unit is o, into the query function
of temperature, press „ ” or „ ” to select Adr, the temperature
zone will display -- or A, B. Where -- refers to the code setting of
the wire controller.
Press “Conrm” into setting state, press „ ” or „ ” to select , then
press “Conrm” to complete it
: The code setting of the wire controller shall prevail.
: The wire controller address setting.
Two - line controller address selection
When the air conditioning unit is o, into the query function of
temperature, press „ ” or „ ” to select INIt, the temperature zone
displayed --.
Press “Conrm” into setting state, press „ ” or „ ” to select to
"ON" , then press “Conrm” to complete it.
: Restore factory Settings.
Restore factory Settings