Rotex A1 BG Inline - Page 6

1 x Safety
6
BA ROTEX A1 BG Inline - 10/2007
Gas installation
• Have the work on the heating and gas supply system carried out only by authorised and trained technical personnel.
• Have work on the gas burner carried out only by authorised and trained technical personnel.
Air/flue gas system (LAS)
• The operator may not modify the air/ flue gas system (LAS) under his authority. Modifications to the combustion air supply
and the flue gas conduction may be made only by authorised and trained technical personnel after approval from the District
Master Chimney Sweep.
Unit installation room
• Only operate the gas condensing boiler if sufficient combustible air supply is guaranteed. If operating the gas condensing
boiler independently of the ambient air with an air/flue gas system (LAS) with dimensions according to ROTEX-Standard, this
is automatically guaranteed and there will be no further conditions required of the device installation room.
• Note that there must be an outside air opening of at least 150 cm
2
for ambient air-dependent operation.
• Do not operate the gas condensing boiler as ambient air-dependent in rooms with aggressive vapours (e.g. hair spray, perchlo-
roethylene, carbon tetrachloride), strong dust formation (e.g. workshop) or high atmospheric humidity (e.g. laundry).
• Strictly keep the minimum distances to walls and other objects (see chapter 7).
Instructions by the installer
• The handover also comprises instructions for operation and inspection of the gas condensation boiler, based on the current
operating manual.
• Document the handover, by filling-in and signing the attached installation and instruction form together with the installer.
Disposal
• Through the environmentally-friendly design of the gas condensing boiler, ROTEX has complied with the standards for
environmentally-friendly disposal.
• Proper disposal in compliance with the respective national stipulations of the country of use is the responsibility of the owner.
Documentation
• The technical documentation included in the scope of supply is part of the device. It must be placed such that the operator
or the technical staff can also refer to it.