1 x Safety
5
BA ROTEX A1 BG Inline - 10/2007
1.3 Danger prevention
ROTEX gas condensing boilers are built according to the state-of-the-art and meet all recognised technical requirements.
However, improper use can cause serious physical injuries or death, as well as property damage. To avoid danger, only install and
operate ROTEX gas condensing boilers:
– As stipulated and in perfect conditions,
– With an awareness of safety and dangers.
This assumes knowledge and application of the contents of this manual and instruction in the operation of the gas condensation
boiler imparted by the installer.
Danger of explosion if you can smell gas
Escaping gas is a direct threat to human life and health. Even minor sparks can trigger major explosions. If you smell gas, please
follow these rules:
• Do not stoke open fire and do not operate an electrical switch.
• Open windows and ventilate the room well.
• Inform the authorised gas supply company.
1.4 Proper use
The gas condensing boiler ROTEX A1 BG xxi can only be used for the heating of hot water heating systems. The gas condensing
boiler must be installed, connected and operated as indicated in this manual.
Any other use outside the above considered as improper. The operator is solely responsible for the damages caused by this.
Proper use also includes the observance of maintenance and inspection conditions. Spare parts must at least satisfy the technical
requirements defined by the manufacturer. This is the case, for example, with original spare parts.
1.5 Instructions for operating safety
Heating system
• Have the work on the heating system (e.g. erection, connection and the initial start up) done only by authorised and trained
heating experts.
• Switch off the mains switch when undertaking any work on the heating system and secure it against being unintentionally
restarted.
• Erect the heating system as open or closed heating system according to the safety engineering requirements given in
EN 12828.
• The safety valves must conform to DIN EN ISO 4126-1 and components must be checked. The safety valves must be installed
in the safety inflow.
• The stickers on the gas condensing boiler must not be removed or damaged.
Electrical installation
• All control and safety devices of the gas condensing boiler are connected ready to operate and checked. Modifications on the
electrical installation are dangerous and prohibited. The operator will be solely responsible for any damage this may cause.
• Only qualified electrical engineers should be allowed to carry out work on the electrical system, observing the valid electrical
engineering guidelines as well as the specifications of the competent electricity supply company.
To Next Page
Loading...
