Section 3 Safety 3-9 S85A / S86A Manual
www.rottlermfg.com
Operating Instructions
Included in this chapter is a general description of how to use this machine for surfacing, whether it
cylinder head, block or other type of job. For details of operating specific fixtures available on this
machine refer to the Optional Equipment Catalog located on the Rottler web site.
There are several ways to use the S85A / S86A machine cutting system depending on the type of work
you do and your personal preferences. Following are some details and descriptions that will help you
decide which method is best suited to your application.
Manual Operation
Use the horizontal slider to move the spindle over to the starting position. The starting position is just
before the cutterhead guard passes over the work piece. Use the vertical slider and position buttons to
get the cutter head close to the proper cutting position. Push the dial depth indicator, on the guard, down
onto the top of the work piece. Assuming the dial indicator has been properly adjusted (see the
Maintenance chapter of this manual for adjustment instructions) it will indicate the depth of the cut at your
current height setting.
Press the up or down vertical move buttons to adjust the depth of the cut. Enter the Feed Rate value and
Spindle RPM value for the desired finish. Press the SPINDLE START button and the FEED LEFT button.
The machine will start Feeding across the work piece.
When the machine has finished cutting, press the START SPINDLE travel button to stop the machine.
Use the vertical slider to raise the spindle up, then horizontal slider to move the carriage back to the
home position.
To Next Page
Loading...
