Section 1 Introduction 1-2 S85A / S86A Manual
www.rottlermfg.com
Description
The model S85A / S86A surfacing machine is a precision, high speed surfacing unit.
The model S85A / S86A can be equipped with tooling and accessories for surfacing most American
passenger car and truck, inline, 90 and 60 degree V-type blocks as well as cylinder heads.
S85A / S86A machines may be readily tooled to resurface a wide variety of engines, including European
and Asian models, as well as perform various other surfacing operations.
This machine is designed for two purposes:
1. The alignment of the deck surface to the pan rails and main bearing locations, as have been done in
the original factory surfacing.
2. A considerable savings in surfacing time and operator involvement as a result of fast block clamping,
and convenient controls.
Change over or resetting time required to set up V-type or in-line engines is a minimum, making this
machine highly suited to the jobber shop where engines cannot be run through, in model lots.
All feeds and rapid travels are power operated and controlled from the conveniently located control panel.
Power required is 230 volt, single phase. This provides power to the variable speed AC motor controller,
the horizontal S.C.R. drive, and various relays and solenoid valves that actuate mechanical controls on
the machine to engage feeds and travels.
Disclaimer
The S85A / S86A Manual (henceforth to be referred to as the “Manual”) is proprietary to Rottler
Manufacturing LLC. (“Rottler Manufacturing”) and no ownership rights are hereby transferred. No part
of the Manual shall be used, reproduced, translated, converted, adapted, stored in a retrieval system,
communicated or transmitted by any means, for any commercial purpose, including without limitation,
sale, resale, license, rental or lease, without the prior express written consent of Rottler Manufacturing.
Rottler Manufacturing does not make any representations, warranties or guarantees, express or implied,
as to the accuracy or completeness of the Manual. Users must be aware that updates and amendments
will be made from time to time to the Manual. It is the user’s responsibility to determine whether there
have been any such updates or amendments. Neither Rottler Manufacturing nor any of its directors,
officers, employees or agents shall not be liable in any manner whatsoever to any person for any loss,
damage, injury, liability, cost or expense of any nature, including without limitation incidental, special,
direct or consequential damages arising out of or in connection with the use of the Manual.
Rottler Manufacturing and its employees or representatives are not responsible for any information
regarding final specifications of any workpiece that is created as a final product when using Rottler
equipment. It is the responsibility of the end user of Rottler equipment to determine the final dimensions
and finishes of the workpiece that they are working on. Any information regarding final dimensions and
finishes that appears in any Rottler literature or that is expressed by anyone representing Rottler is to
be regarded as general information to help with the demonstration of or for operator training of Rottler
equipment.
To Next Page
Loading...
