6
P/N 1011271 Rev. A 06/14
Remove the Bun Feeder. Install the Release Sheet evenly over the platen.
Reinstall the Bun Feeder.
1
INSTALLING THE RELEASE SHEET
The Release Sheet allows buns to pass through the
toaster without sticking. The toaster should never be
operated without a clean Release Sheet installed.
BUN THICKNESS COMPRESSION
KNOB SETTINGS
The toaster uses two Bun Thickness
Compression Knobs for proper toasting
of buns (heels and crowns).
For best results, set both Bun Thickness
Compression Knobs to 4.
The compression settings range from
1 to 6. Setting 1 is the thinnest setting
and Setting 6 is the widest setting.
WARNING
Do NOT operate the toaster without the
release sheet installed. Do not use any
abrasive cleansers or tools such as scrub-
bers or scrapers on the Platen. Damage to
the Platen from operation without a Release
Sheet or damage caused from abrasive
cleansers or tools voids the warranty.
To Next Page
Loading...
