There could be three possible reasons:
You may not be using a Genuine Class 10, U3 High-speed
memory card.
The rear camera's 2.5mm jack connector is not connected
properly.
The rear camera or the cable might be defective.
WHY IS MY ROVE R3 IS STARTING & STOPPING
RECORDING WHEN THE CABLES ARE PROPERLY
CONNECTED?
3
1.
2.
3.
Make sure you use only a genuine Class 10, U3 speed
micro SD card. We strongly suggest the ROVE Ultimate
Micro SD card.
Please remove the 2.5MM Jack from the rear camera's
female jack and then re-insert while ensuring those
male/female prongs are set in place so you don't see the
metallic 2.5mm pin.
Disconnect the rear camera from the main/front camera
and check if the issue persists. If the front/main camera is
recording properly, then, your rear camera or cable might
be defective. Please reach out to our Customer Care to
assist you further.
1.
2.
3.
80
USER MANUAL
To Next Page
Loading...
