The firmware update over the ROVE App was not installed
properly. Either the camera's power supply got disconnected or
the app accidentally closed/timeout during the update process
or the installation of firmware did not reach 100% successfully.
WHY DON'T I SEE ANY ICONS VISIBLE ON THE SCREEN
OR CAMERA'S TOUCH SCREEN IS UNRESPONSIVE AFTER
THE AVAILABLE FIRMWARE UPGRADE?
This is an easy fix. Please reach out to our Customer Care to
assist you with manually reinstalling the firmware to make
your camera up and running again.
4
You might probably be using low AMP fuse slot (5 AMP fuse),
thus, when other accessory using the same fuse turns ON, the
disributed power gets divided and the voltage of the fuse
becomes less which is not enough to supply power to the
camera causing it to restart.
AFTER INSTALLING THE R3 ULTIMATE HARDWIRE KIT,
MY R3 IS GETTING PROPER VOLTAGE BUT WHY DOES
R3 RESTARTS WHEN THE OTHER ACCESSORIES IN MY
CAR ARE RUNNING?
Please use the 15A or 20A fuse so that it can maintain the
voltage even when the voltage is distributed to another
accessory.
5
81
To Next Page
Loading...
