OPC90 Server
7.20 Output Remote Control Memory (ORCM)
The ORCM OPC90 block interfaces with Bailey consoles as a Remote Control
Memory block (function code 62). Note that this block does not received data
from a RCM block running in a Bailey controller. Use the OPC90 RCM block for
that purpose. The ORCM is used to indicate on/off control of a simple discrete
device with a single feedback signal.
Restrictions: This OPC block can be utilized with all Bailey interface types except
CIU01, serial port module (SPM, CPM02 & CPM03) and computer interface
command series (CIC).
TAGNAME TYPE ACCESS DESCRIPTION
ADDR_RING VT_I2 Config/Read Bailey CIU ring address.
ADDR_NODE VT_I2 Config/Read Bailey CIU node address.
ADDR_MODULE VT_I2 Config/Read Bailey CIU module address.
ADDR_BLOCK VT_I2 Config/Read Block number to establish this point at within
the Bailey interface (see note 1).
ADDR_RING VT_I2 Config/Read Bailey CIU ring address.
RCM_TYPE VT_I2 Config/Read ode to use when
note 2).
Bailey RC, type c
establishing this point (see
MAX_TIME VT_I4 Config/Read If OUT never changes, it will be reported at
conds) defined the maximum time interval (se
by this attribute.
MESSAGE VT_BSTR Read ssage. Provides the block operational me
TAG VT_BSTR Read Provides the block name.
TAGLONG VT_BSTR Read ame. Provides the block long OPC path n
TAGDESC VT_BSTR Read Provides the block descriptor.
QUALITY VT_BOOL Read/Write values Current quality (see note 3) of Bailey
(0-good, 1-bad).
OUT VT_BOOL Read/Write f discrete output. Value o
RED_TAG L VT_BOO Read/Write Device red tag indicator.
ALARM VT_BOOL Read/Write Indicates alarm condition.
F1 VT_BOOL Read/Write Current state of feedback signal.
SET_PERM VT_BOOL Read/Write Set permissive (see note 4).
SET_INPUT VT_BOOL Read/Write Indicates state of set input.
RESET_INPUT OL VT_BO Read/Write Indicates state of reset input.
OVR_STATUS VT_BOOL Read/Write Indicates override status condition.
1.) Make sure the block number attribute is unique with respect to the other AOL, DOL, ODD,
ORCM, ORMC, ORMSC and C 90
CE block. ck nu tribute
um numb lowed up
The Bailey system will receive data from this iley
nterface, m o and mber
2.) The RCM type code is a num he f its
RCM faceplate display. Valid codes can be –
Feedback signal to be displayed.
e Devic t b lity of max exception timeout” property is enabled, the
Y tag of ill bad if w in the
n Repo ax setting o y will
OSTN OP 90 blocks associated with the same OPC
DEVI
maxim
The blo
er of al
mber at must also be defined within the range of 1 to
within the associated OPC90 DEVICE block.
block at the ring and node address of the Ba
outputs set
CIU i odule tw block nu defined by the block attribute.
Bailey consoles to identify characteristics o
the sum of: 1 – Output value not displayed, 2
ber used by t
3.) When th e block “Se ad qua
QUALIT
Exceptio
this block w
rt Output M
be set
Time
rites to the block input(s) do not occur with
f the block. When this occurs, bad qualit
The RoviSys Company Version 7.0 Page 94
To Next Page
Loading...