Rowse Ultimate V-Rake - Section C: Operating Instructions; Introduction; Operating Safety; Important

7
C
SECTION C:
OPERATING INSTRUCTIONS
Introduction
1. This section deals with the operating instructions of
the Ultimate V-Rake. For assembly instructions, refer
to Section B.
2. Occasionally, reference is made to certain areas of
the Ultimate V-Rake. Here are explanations of these
phrases.
a) “Right” and “Left” — as viewed from behind the
machine.
b) “Front” or “Rear” of the Rake — the “front” is the
part closest to the tractor.
c) “Inside” or “Outside” — The “inside” is the side
closest to the center of the machine; “outside” is
the side away from the center of the machine.
3. Check and retighten all bolts, nuts, and set screws:
a) After initial 10 hours of use,
b) And again after every 50 hours of use.
c) Refer to the Bolt Torque Chart in Section A.
Operating Safety
Observe these instructions for your safety and for
the safe operation of the equipment.
DANGER
Do not ride or work on
equipment when it it is moving,
or is in a raised position.
! !
WARNING
Be aware of and stay clear of
pinch points that exist
around the equipment.
!
CAUTION
1. When hitching the Ultimate V-Rake to the tractor,
do not allow anyone to get between the tractor
and the Rake.
2. Operate at a safe speed.
a) Reduce speed when transporting
over rough ground.
3. Be sure to always use the SMV (Slow Moving
Vehicle) reector when using public roads.
!
IMPORTANT:
1. Review the Operator’s Manual and
all safety items before working with,
maintaining, or operating the V-Rake.
2. Machine must be in motion when
positioning wings in raking or
transport position.
3. Machine must be in motion when
adjusting width of machine.