19
E
SECTION E:
SERVICE
Safety Reminders
DANGER
1. Do not ride or work on equipment
when it it is moving, or is in a raised
position.
2. Be aware of and stay clear of
pinch points that exist around the
machine.
! !
WARNING
1. High Pressure Fluid Hazard — To
prevent serious injury or death from
high-pressure uid:
a)
Relieve pressure on system before
repairing, adjusting, or disconnecting.
b) Wear proper hand and eye protection
when searching for leaks. Use wood
or cardboard instead of hands.
c) Keep all components in good repair.
!
CAUTION
1. When lubricating or working on the V-Rake
make sure it is resting on the ground. If it is in a
raised position, the V-Rake should have proper
supports to prevent the machine from falling.
2. When lubricating and working around the
V-Rake be careful not to get cut on any other
sharp edges.
!
Tighten Bolts
1. Check and retighten all bolts, nuts, and set screws:
a) After initial 10 hours of use.
b) And again after every 50 hours of use.
c) Refer to Bolt Torque Chart in Section A.
To Next Page
Loading...