FLEX -AUGER
ROXELL - 031 - 0516
TO INSTALL THE RETURN TANDEM SYSTEM (MODEL 75 & 90) III-50.....................
TO INSTALL THE TANDEM IN LINE (MODEL 75/90) III-51.................................
TO INSTALL THE TANDEM IN LINE (MODEL 125) III-52..................................
REDUCING THE CAPACITY III-52......................................................
TO INSTALL THE TUBE III-53..........................................................
AUGER STRETCHING (STRAIGHT THROUGH TANDEM) III-54............................
TO INSTALL THE HOPPER LEVEL SWITCH III-55........................................
TO INSTALL THE DROP TUBE LEVEL SWITCH III-55....................................
TO INSTALL THE SENSOR ON A FLAT SURFACE III-56..................................
TO INSTALL THE SENSOR ON A DROP TUBE III-56.....................................
TO INSTALL THE DROP TUBE LEVEL SWITCH IN A LINE WITH EXTENSION BOOT III-57...
TIME DELAY III-58....................................................................
ELECTRICITY .... WATCH OUT ! III-58..................................................
ELECTRICAL SYMBOLS III-59.........................................................
WIRING DIAGRAM FOR 1X230V III-60..................................................
WIRING DIAGRAM FOR 3X230V III-61..................................................
WIRING DIAGRAM FOR 3X400V III-62..................................................
WIRING DIAGRAM CDS FEED SUPPLY SYSTEM III-63...................................
WIRING DIAGRAM AUTOMATIC OUTLET III-64..........................................
FLEX-AUGER FEED MIX III-65.........................................................
GENERAL LAY-OUT OVERHEAD SYSTEM III-69.........................................
FLEX-AUGER OVERHEAD III-70.......................................................
ASSEMBLY III-71/73.....................................................................
ASSEMBLY III-74/75.....................................................................
MOTOR PROTECTION III-76...........................................................
MAXIMUM CABLE LENGTHS TO THE MOTORS III-77....................................
To Next Page
Loading...
