Alpha 583cx User’s Guide 29
Printing the Quick Start Program Confirmation Report
2 Using the round Number keys, press 1212 and then press the Check key.
3 You are now ready to run an X Report.
Example 11: Go to the PRG or Z modes, using the Manager Password 1313
1 Put the PRG key in the Mode key slot and turn it to the PRG or Z
position.
2 Using the round Number keys, press 1313 and then press the Check key.
3 You are now ready to program or take any reports based on your
selection in the first step.
Printing the Quick Start Program Confirmation Report
Now that basic programming is complete, check your results with a Quick
Start Program Confirmation Report.
If you made a mistake during programming, repeat only the step in
question. For example, if only the tax rate is incorrect, just re-program the
tax—you do not need to re-set the time, date, and so on.
To print the Quick Start Program Confirmation Report
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 Using the round Number keys, press 999999 and then press the
Amount Tend Total key.
3 After the Program Confirmation Report prints, press the Feed key to
advance the complete report out of the cash register.
See the next page for an example of this report.
To Next Page
Loading...
Need help?
General
