Alpha 583cx User’s Guide 45
Programming Scrolling Message Display Times
To program the Sales message stop time setting
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 4, press the number of seconds you
want to delay as 2 digits, and press the Charge key.
Setting the Idle Messages
To program the Idle message display after the time appears
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 50, press the number of seconds
you want to delay as 1 digit, and press the Charge key.
To program the Idle message pattern
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 60, press 0 or 1 for your message
display choice, and press the Charge key.
Idle message
display after the
time appears
Number of seconds for the Time
to appear before the Idle
message appears again.
When the Time changes while an
Idle message is running, the time
appears for a few seconds. After
the specified time, the Idle
message appears again.
Settings in
seconds: 0 – 9
0 does not show
the time at all.
Default=5
Idle message
pattern
Setting the Idle message to 0
runs Idle message 1 in the AM
and Idle message 2 in the PM.
Setting the Idle message to 1
combines both Idle messages
and runs them all day.
Settings: 0 – 1
Default=0
To Next Page
Loading...
Need help?
General
