BASIC MOVEMENT AND SHIFTING
STARTING THE ENGINE
Before attempting to start the engine, make sure to follow these steps.
1. Insert the ignition key and turn it to the “ON” position.
2. Turn the fuel valve to “ON”.
3. Place the engine stop switch in the “RUN” position.
4. Set the parking brake.
5. Push the “START” button.
6. Push the throttle lever lightly.
7. Release the START button once the engine starts. Do not depress the START button for
more than 5 seconds at a time. Release the starter button approximately 10 seconds before
attempting to start the engine again.
8. Keep the throttle open slightly while warming up the engine. Make sure the engine is
warm before attempting to ride. This ATV has an automatic clutch. Opening the throttle
quickly will cause the ATV to move forward.
To Next Page
Loading...