Note: Avoid spraying or allowing water to flow over the following places:
· Ignition
switch · Spark
plug · Fuel tank
cap · Carburetor
Use a garden hose at low pressure to remove the majority of dirt or other debris. Hand
wash your ATV with mild soap or detergent and water. Try to thoroughly remove all dirt and
debris without excessive water pressure, even at remote areas
such as between engine cooling fins, linkages or mounting brackets. Cloth rags,
washing mitts or cleaning brushes can be used. Be careful with brushes as they may
scratch plastic or painted surfaces. Rinse the ATV thoroughly with clean water. Dry all
areas using a chamois or soft absorbent cloth.
INSPECTION AFTER CLEANING
Remove the rags or wrapping from the exhaust pipe. For extended life of your ATV, lubricate
according to GENERAL LUBRICATION section.
Follow the procedures in the INSPECTION BEFORE RIDING section to check your ATV for
any problems that may have occurred during your last ride.
STORAGE PROCEDURE
If you do not use your ATV for a long time, it will need special service requiring
appropriate materials, equipment and skill. For this reason, we recommend that you trust
this maintenance work to your authorized service center. If you wish to service the
To Next Page
Loading...