IDLE SPEED ADJUSTMENT
Carburetor idle speed screw on carburetor
To adjust the idle speed:
1. Start the engine and warm it up.
2. Turn the throttle stop screw a in or out so that the engine idle speed is at 1700~+-100
r/min.
Improper adjustment of the idle speed could be hazardous.
An idle speed that is too high could cause the ATV to launch forward when you start the
engine. This may cause an accident. Excessive engine wear may also result if idle speed is
adjusted improperly or when the engine is not fully warmed up. Adjust the idle to the correct
speed. Make sure the engine is fully warm before adjusting the engine idle speed.
To Next Page
Loading...