RPS Blizzard 150 - Page 34

27
To turn the ATV, the rider must use the proper technique. Because this vehicle has a solid
rear axle, both rear wheels always turn at the same speed. This means that if the rear wheels
are getting equal traction, the vehicle will tend to move straight ahead. This is because the
rear wheels will travel the same distance. For the vehicle to turn, the outside rear wheel must
travel a longer distance that the inside rear wheel. To make this happen, the rider must
create less traction for the inside wheel, allowing it to skid. This allows it to travel a shorter
distance than the outside wheel. This happens even though both wheels are still turning at
the same speed.
To turn ATV, use the following technique:
· Move your body weight forward and to the inside of the turn.
· Turn the handlebar while looking in the direction of the turn.
FOR HIGHER SPEEDS OR SHARPER TURNS
Use the same technique that you use when you move your body weight farther toward the
inside of the turn to maintain your balance. Natural turning forces (which can push the
vehicle to the outside of the turn) increase as the speed or the turn sharpness increases.
This means you must lean your body farther into the turn as you go faster or turn more
sharply. This prevents the vehicle from tipping over to the outside of the turn. If your ATV
starts to tip while turning, lean your body farther into the turn while gradually reducing the
throttle and making the turn wider, if possible.