RPS Blizzard 150 - Page 52

45
Preparing the battery:
· Place battery on level surface. Remove sealing
tape from top. (See figure 1)
· Take the electrolyte container out of the plastic
bag.
· Place electrolyte container upside down with the
sealed silver mouths of the electrolyte bottles in
line with the six filler holes of the battery. (See
figure 2)
· Push the container down strongly enough to
break the silver seals. (See figure 3) · As
electrolyte starts flowing into battery, air
bubbles will come up from the mouths of the
plastic electrolyte bottles.
· Leave bottles upside down in battery holes until
electrolyte is completely drained.
· Never leave children unattended around battery.
· If air bubbles cease to float to the top of the
electrolyte bottles, tap lightly on top.
· DO NOT remove container from battery while it
is draining.
· Never cut or pierce electrolyte container.
· After all the electrolyte has drained from the
bottles into the battery, pull plastic electrolyte
bottles gently out of the battery.
· Discard empty electrolyte bottles in a waste area
that is inaccessible to children and animals.
· After filling let battery stand for at least 30
minutes before charging. This allows the
electrolyte to penetrate plates for optimum