8.7.1 - Manual Control cycle
his option can be used if an additional control cycle has to be performed. A control cycle will take maximum
20 minutes. For this step the door has to be closed.
1. Select ‘Log in’
2. Enter credentials
3. Select tab '
Manual’
4. Select "Start Control cycle", initiating the control cycle.
The instrument will start the control cycle once the current process is finalized. Once the cycle is done,
production is continued automatically.
5. Log out or otherwise log-out will occur automatically after 5 minutes of inactivity.
8.7.2 - Replace cubitainer function and adding users
A new cubitainer has to be installed after a reagent warning or error message. After selecting
Replace
cubitainer
the following message appears:
User interface and software menu
52
MRN-184-EN Version 6 (05-01-2022)
To Next Page
Loading...