RSG MCS-16 - F:7 Run Lock

Run Lock
• Outputs - 1 run lock
output, additional outputs
assigned from software
• Enable inputs - Inputs
assigned in software
from handset, handbrake,
remote buttons etc, high
or low inputs
• Reset inputs - Inputs
assigned in software
from brake light, remote
buttons etc, high or low
inputs
Run Lock operating
parameters can be
set-up and defined in the
‘Run Lock User Interface
Module’ that is within
the Installer Program
- see Section K.
RSG Engineering Limited Telephone : 01543 438800 Fax : 01543 438801 Email : sales@rsg-ontop.com Web : www.rsg-ontop.com
1:11
UNIVERSAL CONTROLLER LITE (MCS-16) USER GUIDE V1 F : CONNECTION AND SWITCH DETAILS
F:7 Run Lock
F : Connection and Switch Details