RTA 460 - Supported Protocols; The 460 Gateway Parts; Additional Required Equipment

Default IP Address – 192.168.0.100
460 Gateway User Manual Page 3
Supported protocols
The 460 Gateways connect devices with the following protocols:
• ASCII RS232
• ASCII RS485
• BACnet/IP® Server
• CANopen Slave
• DeviceNet™ Master
• DeviceNet Slave
• EtherNet/IP™ Client
• EtherNet/IP Server
• Modbus® RTU Master
• Modbus RTU Slave
• Modbus TCP Client
• Modbus TCP Server
• Raw TCP Client
• Raw TCP Server
If you would like more information about 460 Gateway configurations, contact Real Time
Automation, Inc. (RTA) at 262.439.4999 or www.rtaautomation.com.
The 460 Gateway parts
The 460 Gateway contains the following parts.
• The 460 Gateway unit
• Power cable
• DIN rail mounting
• Crossover cable to connect a personal computer to the Gateway unit during the initial
setup (or to change settings)
• Null modem cable (two female connectors) to use during debugging, if necessary
• A CD with the user manuals and utilities
Additional required equipment
You need to connect a personal computer to the 460 Gateway just during the initial software
setup or if you need to change settings because of a device change.
You must supply the cables to use for communications after the setup is complete.