Default IP Address – 192.168.0.100
460 Gateway User Manual Page 45
Serialconfiguration(Modules1and2)
If your version of the 460 Gateway requires your gateway to act as a serial device, use the
following steps to configure the gateway. If you are connecting the 460 Gateway to two different
serial devices, repeat these directions to configure Serial Module 2.
Since the 460 Gateway translates data between devices with different protocols, at least two
Communication Modules must be configured.
1. Click on next to the Selected Communication Modules on the RTA 460 Gateway
Main Page. See Figure 2-2.
The Communication Module Configuration screen displays. See Figure 2-59.
Note: The Edit buttons are grayed out when the task applies to a different 460
Gateway version than you purchased. Please contact Real Time
Automation, Inc. (RTA) at 262.439.4999 or www.rtaautomation.com for more
information about 460 Gateway configurations.
Figure 2-59 Communication Module Configuration screen
Edit
To Next Page
Loading...
