20
/
32
1.6 Operating Instructions
When the unit is powered on, the Welcome screen is displayed followed shortly by the
Main Interface screen.
1.6.1 Fast Voltage and Current Setting
Press key to enter the fast Voltage setting mode. Press the rotary control to cycle
through the characters available, place the cursor at the required character, turn the rotary
control clockwise increases the value and anticlockwise decreases the value. Press key
to save the data and exit, alternatively, after 1 minute of inactivity the setting mode will exit
automatically. Press key to set the output Current limit using the same procedure.
1.6.2 Advanced Parameter Setting
On the main interface press the key to enter the Data Setting Interface. In the
Data Setting Interface press key or key to step up or down through the menu
options to select (Voltage) or (Current Limit),and then set the output
I:The actual value of the output Current
N:Normal or abnormal status prompt
J:The actual value of the output Power
O:Constant Voltage or Constant Current status prompt
K:The actual value of the input Voltage
P: Data Group number in use prompt
Q: Output enabled or disabled prompt
V:Preset Over-Power protection value
W:Preset screen brightness level
T: Preset Over-Voltage protection value
X: Preset Data Group number.
U:Preset Over-Current protection value
Y:The actual value of the output Voltage and output Current
To Next Page
Loading...
