RUiXU Lithi2-16 - Page 36

Version: V1.0 Page
32
of 50
manual intervention is
required.
Discharge
over-current/
Overload
The BMS will stop discharging when the discharging
current is higher than the protection value. And it will
release from the protection when the system delays time
is met
Automatic recovery. If
locked after three
consecutive times,
manual intervention is
required.
Short-circuit/Reversed
Short-circuit and Reversed polarity protection happened
Charge to release
Manual reset
Temperature, Voltage,
Current sensor failure
Enter the failure mode, manual intervention is required
no charging and discharging.
Manual intervention
dormancy mode
After reaching a certain condition, it will be in the
dormancy mode
Recoverable